Product ID:ROYCO 11
MSDS Date:04/03/1989
FSC:9150
NIIN:00N027645
MSDS Number: BNMCC

ROYAL LUBRICANTS COMPANY INC.

6 CAMPUS DR
PARSIPPANY, NJ 07054
US

Emergency Phone: 201-887-7411

Info Phone: 201-887-7410

Cage: 07950

ROYAL LUBRICANTS COMPANY INC.

518 EAST HANOVER, NJ 07936 US

Telephone: 973-887-7411/7410

Cage: 07950

MINERAL OIL, PETROLEUM DISTILLATES, HYDROTREATED (SEVERE)

CAS: 64742-54-7

RTECS: PY8035501

Fraction By Weight: 80-90%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

PETROLEUM DISTILLATES)

RTECS: 9999999ZZ

BENTONITE; (INORGANIC CLAY)

CAS: 1302-78-9

RTECS: CT9450000

Fraction By Weight: 5-10%

OSHA PEL 5 MG/M3 (DUST)

ACGIH TLV: 5 MG/M3 (DUST)

FATTY ACID AMIDES

CAS: 68910-93-0

Fraction By Weight: 2-5%

NON HAZARDOUS INGREDIENTS; (OTHER COMPONENTS)

Fraction By Weight: 2-5%

FOLLOWED TO MINIMIZE EMPLOYEE'S EXPOSURE.

RTECS: 9999999ZZ

AIR & PROVIDE O*2 IF BRTHG IS DFCLT. GET MD

RTECS: 9999999ZZ

TREATMENT IS NEC UNLESS LG QUANTITIES OF PROD ARE

RTECS: 9999999ZZ

EMESIS INDUCTION IS UNNECESSARY IN HIGH VISCOSTIY,

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE:MAY BE MILDLY IRRITATING.
SKIN:PRLNGD/RPTD CONT MAY CAUSE VARIOUS SKIN DISORDERS SUCH AS
DERM/FOLLICULITIS/OIL ACNE. RELEASE DURING HIGH PRESS USAGE MAY
RESULT IN INJECTION OF OIL INTO SKIN CAUSIN G LOCAL NECROSIS.
INHAL:NOT EXPECTED TOBE A RELEVANT ROUTE OF EXPOS; HOWEVER, UNDER
HIGH TEMP CONDITIONS, (SUPP DATA)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:LOCAL NECROSIS IS EVIDENCED BY DELAYED ONSET OF
PAIN AND TISSUE DAMAGE A FEW HOURS FOLLOWING INJECTION. OTHER: THIS
SPECIFIC PROD HAS NOT BEEN TESTED IN LONG-TERM, CHRONIC EXPOS
TESTS. LUBRICATING GRE ASES ARE GENERALLY CONSIDERED TO BE OF A LOW
ORDER OF ACUTE TOX TO HUMANS & EXPERIMENTAL ANIMALS. HOWEVER, (SUPP
DATA)
Medical Cond Aggravated by Exposure:PREEXISTING SKIN DISORDERS MAY BE
AGGRAVATED BY EXPOSURE OF THIS PRODUCT.

First Aid:EYE: FLUSH W/WATER FOR AT LEAST 15 MIN HOLDING LIDS OPEN. GET
MD ATTN. SKIN; REMOVE CONTAMD CLTHG & WIPE EXCESS OFF. WASH W/SOAP
& WATER/WATERLESS HAND CLEANER FOLLOWED BY SOAP & WATER. DO NOT
REUSE C LTHG UNTIL THORO CLEANED. IF IRRIT PERSISTS, GET MD ATTN.
IF MATL IS INJECTED UNDER SKIN, GET MD ATTN PROMPLY TO PVNT SERIOUS
DAM; DO NOT WAIT FOR SYMPS TO DEVELOP. INHAL:REMOVE TO FRESH (ING
7)

Flash Point Method:PMCC
Flash Point:390F,199C(ING 1)
Extinguishing Media:USE WATER FOG/DRY CHEM/CO*2. DO NOT USE A DIRECT
STREAM OF WATER. PROD WILL FLOAT & CAN BE REIGNITED ON SURF OF
WATER.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT . COOL FIRE EXPOSED CONTAINERS SURROUNDING
EQUIPMENT AND STRUCTURES WITH WATER.
Unusual Fire/Explosion Hazard:NONE SPECIFIED BY MANUFACTURER.

Spill Release Procedures:SCOOP UP EXCESS GREASE. CLEAN AREA WITH
APPROPRIATE CLEANER. SPILLS ENTERING SURFACE WATERS, OR WATER
COURSES/SEWERS ENTERING/LEAVING TO SURFACE WATERS THAT CAUSE A
SHEEN MUST BE REPORTED TO NRC.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE WITH
ADEQUATE VENTILATION. KEEP AWAY FROM OPEN FLAMES AND HIGH
TEMPERATURES.
Other Precautions:MINIMIE SKIN CONTACT. PROPERLY DISPOSE OF
CONTAMINATED LEATHER ARTICLES, INCLUDING SHOES, THAT CANNOT BE
DECONTAMINATED.

Respiratory Protection:NOT ORDINARILY REQUIRED. NIOSH/MSHA APPROVED
RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:NONE SPECIFIED BY MANUFACTURER.
Protective Gloves:OIL RESISTANT GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:CLOTHING AS NEEDED TO MINIMIZE SKIN CONTACT.
Work Hygienic Practices:WASH W/SOAP & WATER BEFORE EATING, DRINKING,
SMOKING OR USING TOILET FACILITIES. LAUNDER CONTAMD CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
HAZ DECOMP PROD:PARTICULATES & GASES WILL EVOLVE WHEN MATL UNDERGOES
PYROLYSIS/COMBUST. CO & UNIDENTIFIED ORGANIC COMPOUNDS MAY BE
FORMED UPON COMBUST. HLTH HAZ:VAPS IRRITATING TO NOSE, THROAT &
UPPER RESP TRACT MAY BE PRODUCED. EFTS OF OVEREXP:THE HANDLING
PROCEDURES & SAFETY PRECAUTIONS IN MSDS SHOUD BE (ING 6)

HCC:V6
Solubility in Water:INSOLUBLE
Appearance and Odor:DARK AMBER, SMOOTH, SLIGHT ODOR.

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:AVOID HEAT, OPEN FLAME & CONTACT WITH
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:THERMAL DECOMP PRODS ARE HIGHLY
DEPENDENT ON COMBUST CONDITIONS. A COMPLEX MIX OF AIRBORNE SOLID,
LIQ (SUPP DATA)

Waste Disposal Methods:DISPOSE OF IN AN APPROPRIATE DISPOSAL FACILITY
IN COMPLIANCE WITH LOCAL, FEDERAL AND STATE REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.